Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800) 526-4371
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity:
MSDS No.
Cyan Toner for 5711 / 5811
CP- 325
Product ID:
117-0310
Issued: 9/2/99
Supersedes: None
Synonyms
& Common
Names:
Date: 9/2/99
Cyan Toner for
Lanier 5711, 5811
Prepared by: Lanier QA/EH&S Department 770-493-2361
Approved by: Larry Choskey, Sr. Quality Assurance Engineer
European Contact: Lanier Worldwide, WSM Europe,
Walter Fricke,
Uses:
Lanier 5711, 5811 Color Copier
Mixture
Im Taubental D-41468 Neuss, Germany
+49-2131-387-177
Chemical
Formula:
Section 2: Composition / Information on Ingredients
PERCENT
85 – 95 % by weight
1 – 5 % by weight
CAS No.
N/a
EXPOSURE LIMITS
SOURCE
Polyester resin
Pigment
N/a
N/a
N/a
N/a
N/a
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 1
REACTIVITY = 0
HEALTH = 1
SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-toxic dust.
Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): Not known.
Section 4: First Aid Measures
Remove to fresh air if effects occur. Gargle with water.
Get medical attention if needed.
In case of contact, immediately flush eyes with
water for 15 minutes. Get medical attention if
needed.
Dilute stomach contents with several glasses of
water. Get medical attention if needed.
Inhalation:
Eye Contact:
Ingestion:
Skin Contact:
Wash with soap and water.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
Unusual Fire and Explosion Hazards: Toner material, like most
organic material in powdered form, is capable of creating a dust
explosion.
Flammability: Non-flammable solid The decomposition products are CO, CO2,. Avoid inhalation of smoke.
Special protective equipment for fire fighters: none
UEL: n/a
LEL: n/a
Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or
3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold
water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Section 7: Handling and Storage
Special Handling:
Special Storage:
Cleanse skin after contact before breaks or meals, and end of workday.
Store in a cool, dry place. Avoid direct sunlight. Keep out of reach of children. Keep from contact with oxidizing materials.
Do not handle in windy areas. Flying powder may enter eyes. Minimize inhalation of dust. Cleanse skin thoroughly after
contact, before breaks and meals, and at end of work periods.
Miscellaneous:
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use.
Hand Protection: none required under normal use.
|