CHARGING INSTRUCTIONS (continued)
9 Volt Size (Manual “Overnight” Charge)
1.
Connect one or two 9V NiCd or NiMH type batteries to the charger and the green
LED’s next to them will light.
2.
Depending on the capacity of the 9V battery to be charged, leave the battery on
the charger for 10 – 15 hours according to the table below. The LED will stay on
even after the charge time has been reached. Remove the battery which is now
ready to use. Unplug the charger when not in use.
Model PRO541
Rechargeable Nickel Metal-Hydride
Batteries and Charger
CHARGING TIMES:
5 hours – NiCd
8 Hours – NiMH (D size, 5000mAh cells require two 8 hr. charge cycles, 16 hrs. total)
9V Battery – 110mAh (10 hours), 150-160mAh (15 hours)
Owner’s Manual
Thank you for purchasing the NoMEM PRO Battery System. Please read this manual
carefully. It contains important operating instructions for your NoMEM PRO
Rechargeable Battery System. This PRO541 charger will quickly and efficiently charge
all AA, AAA, C, D and 9V size Nickel Cadmium (NiCd) or Nickel Metal-Hydride (NiMH)
batteries.
CAUTION:
Do not overcharge the batteries. For indoor use only. This NoMEM PRO charger is
intended for use with Nickel Metal-Hydride and Nickel Cadmium batteries only.
Attempting to charge any other type of battery may cause personal injury and damage
to the charger. Never charge NiMH and NiCd batteries at the same time.
Warning:
•
•
Charge only NiCd or NiMH batteries on this charger.
Do Not mix NiCd and NiMH batteries together when charging or using.Keep all
NiMH batteries and NiCd batteries separate.
Batteries may leak or explode causing personal injury if inserted improperly,
disposed of in fire, mixed with other battery types, or short circuited.
Warranty
NoMEM PRO chargers are warranted to be free of manufacturing defects for 2 years
from the original date of purchase. If, during the warranty period, any part fails to
function properly under normal use because of manufacturing defects or workmanship,
it will be repaired at no charge for parts and labor or, at our option, the product will be
replaced. The following is excluded: damages from delay or loss of use of equipment,
or damaged batteries, malfunctions resulting from misuse, tampering, unauthorized
repairs, modifications, or accident. To obtain warranty service, package the unit and its
accessories carefully using ample padding material to prevent damage in transit and
ship it prepaid and insured to:
•
CHARGING INSTRUCTIONS
AA, AAA, C & D Size (Automatic Quick Charge)
1.
Slide the battery type switch to the proper position for charging either
“Ni-MH” for NoMEM PRO or other Nickel Metal-Hydride batteries, or to
“Ni-Cd” to charge Nickel Cadmium batteries. Each battery position can only hold
1 battery at a time, do not stack 2 or more batteries in one position. Insert 1-4
batteries into the charger by pulling back the spring loaded chrome “-“ battery
contact, insert the batteries to be charged observing the polarity marked inside
the charger, and release the spring contact to allow it to make contact with the
battery.
Plug the charger’s cord into any typical household outlet. The indicator LED will
glow Red in each battery position where a battery is installed, showing charging
is taking place. After the proper charge time, the LED’s will turn off to indicate
that the charge is complete and batteries are ready for use. The charger will
switch to “trickle” mode to keep the batteries at full. Due to the extra high
capacity of NiMH D cells (5000mAh), two charge cycles are required to charge
fully from empty.
LENMAR ENTERPRISES, INC.
4035 VIA PESCADOR
CAMARILLO, CA 93012.
When sending in product for service, your package should include evidence of date
and place of purchase. Enclose $10.00 for shipping and handling for addresses in the
U.S. and $15.00 in Canada. For outside the U.S. and Canada, freight will vary
depending upon ship to address.
2.
For further information contact
Lenmar Enterprises, Inc.
Phone: 805/384-9600
E-mail: [email protected]
3.
Remove batteries and unplug charger once charge is complete. Do not leave
batteries in charger for extended periods of time OR when the charger is not
plugged in. Unplug the charger when not in use.
4.
Begin again at Step-1 to charge the next set of batteries.
|