Date:
MSDS No.:
1/5/2009
CAN-F10-C
Trade Name:
Sizes:
Lincolnweld 761 and 761 PIPE
---
7/20/2007
Supersedes:
M A T E R I A L S A F E T Y D A T A S H E E T
For Welding Consumables and Related Products
Conforms to Workplace Hazardous Materials Information System (WHMIS) Rev. November, 1988
Section I & II - Preparation and Product Information
Product Type:
Representative Classifications:
Submerged Arc Flux
CSA F49A3-EL12
F49A3-EM12K
The Lincoln Electric Company of Canada LP
179 Wicksteed Avenue
Toronto, Ontario M4G 2B9 CANADA
Phone: (416) 421-2600
Prepared by The Lincoln Electric Company, Cleveland, Ohio, USA
(216) 481-8100, on the date shown above.
Section III - Hazardous Ingredients (1)
I M P O R T A N T !
This section covers the materials from which this product is manufactured. The fumes and gases produced during welding with the normal use of this
product are covered by Section VII; see it for industrial hygiene information.
CAS Number shown is representative for the ingredients listed.
(1)
The term “hazardous” in “Hazardous Ingredients” should be interpreted as a term required and defined in the Hazardous Products Act and does
not necessarily imply the existence of any hazard.
TLV
LD50
LC50 mg/m3
Ingredients:
Quartz
CAS No. Wt. % mg/m3 (Route/Species) (Route/Species)
200 mg/kg LDLo
(intratracheal/rat)
300 LCLo
(inhalation/human)
14808-60-7
1309-48-4
7439-96-5
1344-09-8
7789-75-5
7440-21-3
13463-67-7
7439-89-6
1344-28-1
14464-46-1
1332-58-7
12004-83-0
35
10-30
15
#0.05**
Magnesite
10
Not Available
9 g/kg
(oral/rat)
1153 mg/kg
(oral/rat)
4250 mg/kg
(oral/rat)
Not Available
2.3 LCLo
(inhalation/human)
Manganese and/or manganese alloys and compounds (as Mn)
Silicates and other binders
Fluorides (as F)
0.2
5-10
1-5
10*
2.5
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Not Available
Silicon and/or silicon alloys and compounds (as Si)
Titanium dioxides
1-5
10*
10
Not Available
Not Available
Not Available
Not Available
1-5
Iron
0.1-1
0.1-1
0.1-1
0.1-1
0.1-1
10*
10
Aluminum oxide and/or Bauxite
Crystalline-Silica (cristobalite)
Mineral silicates
10,000 mg/kg
(oral/rat)
#0.025**
5**
5
590 g/kg LDLo
(oral/rat) reproductive
Zirconium alloys and compounds (as Zr)
Not Available
Notes:
(LDLo, LCLo) Lowest published toxic concentration.
(*)
Not listed. Nuisance value maximum is 10 milligrams per cubic
(#)
Crystalline silica (quartz) is on the IARC (International
Agency for Research on Cancer) and NTP (National
Toxicology Program) lists as posing a carcinogenic risk
to humans.
meter. TLV value for iron oxide is 5 milligrams per cubic meter.
(**)
As respirable dust. Value for respirable quartz is 0.1 milligrams
per cubic meter.
Section IV - Physical Data
Physical data such as odor, vapor pressure, density, evaporation rate and freezing or boiling points are not listed as they are not applicable to this product and
its use.
Section V - Hazard Data
Non Flammable; Welding arc and sparks can ignite combustibles and flammable products. See CSA W117.2 Section 9.7 as referenced in Section VIII.
Product is inert, no special handling or spill procedures required.
Rev 9/07
(CONTINUED ON SIDE TWO)
|