®
COPPER-FIN
WATER HEATER
Submittal Sheet
CW-Sub-09
®
COPPER-FIN GAS WATER HEATERS (MODELS CW495-2066)
JOB NAME ______________________________________________________________________
LOCATION ______________________________________________________________________
ARCH./ENGR.____________________________________________________________________
MECH. CONTRACTOR ___________________________________________________________
MODEL NO. _____________________________________________________________________
TYPE GAS ______________________________________________________________________
Btu/hr INPUT____________________________________________________________________
RECOVERY RATE IN GPH_______________________________________@________°F RISE
NOTES
Standard Features
Optional Equipment
Alarm Bell
• 81% Thermal Efficiency
• Electronic Temperature Control
• Fan Assisted Combustion
• Sealed Combustion Chamber
• Stainless Steel Burners
• Low NOx Operation Exceeds the most
Stringent Air Quality Requirements
• ASME Copper Finned Tube Heat Exchanger
• 160 psi Working Pressure
• Gasketless Heat Exchanger Design
• All Bronze Circulating Pump
• Pump Delay w/ Freeze Protection
• Remote Tank Thermostat
Contacts on any Failure
Contacts for Air Louvers
Cupro-Nickel Heat Exchanger
High Gas Pressure Switch w/ Manual Reset
Low Gas Pressure Switch w/ Manual Reset
Low Water Cut-Off
Probe Type
Probe Type w/ Test
MP2 Sequencer
Multi-Stack Frame
Solenoid Gas Valve
• Glass-Lined Water Surfaces
• Referenced Gas Valves
• Loch-Heat Ceramic Tile Combustion Chamber
• Hot Surface Ignition
• ASME Temperature & Pressure Relief Valve
• Adjustable High Limit w/ Manual Reset
• Inlet/Outlet Temperature Gauges
• Flow Switch
Available Firing Systems
F9 HSI (Standard)
F13 GE GAP/FM
F7 California Code
• 24 Volt Control System
• BMS Terminal Strip
• Combustion Air Filter (986-2066)
• 5 Year Limited Warranty on Heat Exchanger
(See warranty for details)
|