user guide
manual del
usuario
™
iFlip 8.4”portable video player for iPod®
™
Reproductor de video portátil iFlip para iPod con pantalla de 8.4”
*Compatible with iPod devices with docking capability (iPod unit sold separately)
*Compatible con iPod con conector dock (la unidad de iPod se vende por separado)
Mi8000-BLK
Please read these instructions
completely, before operating
this product.
Por favor lear instruciones
completamente, antes de
usar este producto.
SAFETY PRECAUTIONS
INFORMATION:
This equipment complies with Class B digital device regulations.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty
for this product.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
2
Dear Customer:
Selecting fine audio and video equipment such as the unit you’ve just purchased
is only the start of your musical enjoyment. Now it’s time to consider how you
can maximize the fun and excitement your equipment offers. This manufacturer
and the Electronic Industries Association’s Consumer Electronics Group want
you to get the most out of your equipment by playing it at a safe level. One that
lets the sound come through loud and clear without annoying blaring or
distortion-and, most importantly, without affecting your sensitive hearing.
Sound can be deceiving. Over time your hearing “comfort level” adapts to higher
volumes of sound. So what sounds “normal” can actually be loud and harmful to
your hearing. Guard against this by setting your equipment at a safe level
BEFORE your hearing adapts.
To establish a safe level:
• Start your volume control at a low setting.
• Slowly increase the sound until you can hear it comfortably and clearly, and
without distortion.
Once you have established a comfortable sound level:
• Set the dial and leave it there.
Taking a minute to do this now will help to prevent hearing damage or loss in the
future. After all, we want you listening for a lifetime.
We Want You Listening For A Lifetime
Used wisely, your new sound equipment will provide a lifetime of fun and
enjoyment. Since hearing damage from loud noise is often undetectable until it is
too late, this manufacturer and the Electronic Industries Association’s Consumer
Electronics Group recommend you avoid prolonged exposure to excessive noise.
This list of sound levels is included for your protection.
Decibel
Level
30
Example
Quiet library, soft whispers
40
Living room, refrigerator, bedroom away from traffic
Light traffic, normal conversation, quiet office
Air conditioner at 20 feet, sewing machine
Vacuum cleaner, hair dryer, noisy restaurant
Average city traffic, garbage disposals, alarm clock at
two feet
50
60
70
80
THE FOLLOWING NOISES CAN BE DANGEROUS UNDER
CONSTANT EXPOSURE:
EIA
EST. 1924
90
Subway, motorcycle, truck traffic, lawn mower
Garbage truck, chain saw, pneumatic drill
Rock band concert in front of speakers, thunderclap
Gunshot blast, jet engine
100
120
140
180
Rocket launching pad
We
WantYou
LISTENING
Information courtesy of the Deafness Research Foundation.
ForALifetime
3
LOCATION OF CONTROLS
MAIN UNIT
1. S-VIDEO Jack
(Side of Unit)
2. LINE OUT Jack
(Side of Unit)
3. Headphones 1 Jack
(Side of Unit)
4. Headphones 2 Jack
(Side of Unit)
9. MENU Button
10.Battery (Charging)
Indicator
11.Power Button
12.POWER IN Jack
13.Fully Charged Indicator
14.Power On Indicator
15.- / + (Volume/Setting)
Button
5. Left Speaker
6. Cradle Dock for use
with iPod
16.Right Speaker
7. Dock Release Button
8. Screen
4
POWER SOURCE
AC CONNECTION
Insert the small end of the AC adapter into the POWER IN jack (located on the side of
the unit). Connect the AC cord to the adapter and connect the other end to a wall outlet
having 120V AC, 60 Hz. AC Adapter, DC 12V Z
AC Outlet
AC Plug
NOTES:
•
The AC adapter supplied with the unit is polarized to help minimize the possibility
of electric shock. If the AC plug does not fit into a nonpolarized AC outlet, do not
file or cut the wide blade. It is the user’s responsibility to have an electrician replace
the obsolete outlet.
•
•
Remove both the DC plug and the AC-IN plug to disconnect the AC adapter when
not in use.
Only use the supplied AC Adapter which has the following specs: DC 12V Z
CHARGING THE INTERNAL BATTERY PACK
When the Mi8000 is operating on AC power (as described above), it will also charge
the internal battery pack. While the battery pack is charging, the Battery (Charging)
indicator will light amber. When the battery pack is full, the Fully Charged indicator will
light green.
NOTES:
•
•
•
•
•
When the battery is low, the Battery (Charging) indicator will flash amber.
Fully charge the battery pack (6.5 hours) before using it for the first time.
Make sure the battery packs is charged at least once a year.
When fully charged, the unit can be used for up to 5 hours.
For iPod charging, please refer to page 7 for details.
5
OPTIONAL FEATURES
S-VIDEO JACK (Side of Unit)
If you are using an iPod with video (5th generation) or iPod photo, and your TV has
an S-Video input, you can connect the Mi8000 to the external TV with an S-Video
cable. You will then be able to view the photos/videos from the iPod on your external
TV.
NOTES:
•
•
Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
When connecting the Mi8000, refer to the owner’s manual of the TV, as well as
this manual.
•
•
When connecting the Mi8000 to the TV, make sure the power is off and both
units are unplugged before making any connections.
Make sure to go into the Settings menu of your iPod and set the TV Out setting
to ON; otherwise, you may not be able to view the videos/photos on your
external TV.
LINE OUT JACK (Side of Unit)
By using a home audio connection cable, superb sound can be heard through your
home audio system. Before making any connections, turn off the power to all
equipment.
Plug a connection cable between the LINE OUT jack on the side of the Mi8000 and
the amplifier’s LINE or AUX IN jack. (Do not connect it to the amplifier’s
Headphones jacks.)
NOTE: If the Mi8000 interferes with TV or radio reception, move the Mi8000 away
from the TV or radio or turn off the power to the Mi8000.
6
INSERTING AN iPod
1
2
Press the Dock Release button.
Locate the correct holder to use as
shown on page 10. Insert the
holder onto the dock (as shown)
and slip the side tabs into place.
IMPORTANT NOTE:
If you are using the holder marked
“A compatible with any iPod with
dock connector”, please insert the
iPod universal dock (not included)
corresponding to your iPod model
onto the dock. Then, insert the
holder followed by the iPod.
Insert the iPod onto the holder.
Gently push down so the
connector on the iPod slides onto
the connector on the Mi8000.
Press the edge area of the holder
down gently (as shown) until it
clicks into place.
NOTES:
•
To remove, press the Dock
Release button again. Then,
remove the iPod first, followed
by the holder.
•
Do not press the holder by
pushing the iPod.
3
Once you connect the iPod, it will
start charging the battery until it is
full. (The iPod can charge only
when the Mi8000 is connected with
the AC adapter.) When the iPod is
connected to the Mi8000, it will be
in Charging mode until the battery
is full. Please see the next page for
instructions on using an iPod with
this unit.
7
OPERATION
USING AN iPod WITH THIS UNIT
1
2
With an iPod connected (see
previous page), turn the Mi8000 on
by pressing and holding the Power
button (if it is not on already); the
Power On indicator will light green.
Operate the iPod as per its
owner’s manual.
For music selections, the sound
will be heard through the Mi8000’s
speakers.
For photo selections, the image
will be seen on the Mi8000’s
screen.
For video selections, the sound
will be heard through the Mi8000’s
speakers and the image will be
seen on the Mi8000’s screen.
NOTES:
•
Make sure to go into the Settings menu of your iPod and set the TV
Out setting to ON and set the TV Signal to NTSC; otherwise, you may
not be able to view the videos/ photos on your external TV.
The photo and video selections are for iPod with video (5th
generation). The photo selection is also suitable for iPod photo.
•
3
4
Adjust the volume as desired by
When done, press and hold the
Power button (the Power On
indicator will go out) and also turn
off the iPod.
pressing the - / + (Volume/Setting)
button.
For private listening, plug in
headphones into the Headphones
jack(s) on the side of the Mi8000.
The speakers will be disconnected
when headphones are plugged in.
8
OPERATION (CONTINUED)
SETTING THE MENUS
1
2
1
1
2
2
With the Mi8000 on, press the
MENU button 1; the menu will
appear. To adjust the Brightness,
Contrast, Sharpness, Color or Hue,
select the desired option by
repeatedly pressing the MENU
button 1. Then adjust the option by
pressing the - / + (Volume/Setting)
button 2, followed by the MENU
button 1 again.
To adjust the Screen Mode, select
Screen Mode by repeatedly
pressing the MENU button 1. Then
select between 16:9 (Wide Screen)
and 4:3 (Pan Scan: video material
formatted in this style is played back
with the left and right edges cut off)
by pressing the - / + (Volume/
Setting) button 2, followed by the
MENU button 1 again.
3
4
1
1
2
2
To reset the unit back to its factory
settings, select Default by
repeatedly pressing the MENU
button 1. Then press the - / +
(Volume/Setting) button 2.
To exit the menu, select Exit by
repeatedly pressing the MENU
button 1. Then press the - / +
(Volume/Setting) button 2.
9
OPERATION (CONTINUED)
iPod HOLDERS
Locate your iPod in the chart below and select the respective holder (the
Holder No. is marked at the back of the holders as shown below) to match
with your iPod. Insert the corresponding holder and your iPod into the unit as
described on page 7.
iPod
Type
Memory Holder No.
Fifth
30GB
No. 9
iPod with video
30GB
Generation
iPod with
video
No. 10
iPod with video
60GB/80GB
60GB/
80GB
NOTE:
•
For all other iPod models, please use the holder marked “A compatible
with any iPod with dock connector”.
IMPORTANT!
The Holder No. is marked at the
back of the holders. Please refer
to the illustration to the left for the
location of the Holder No.
10
TROUBLESHOOTING GUIDE
If you experience a problem with this unit, check the chart below before
calling for service.
SYMPTOM
CAUSE
SOLUTION
No sound from iPod.
Volume is
Increase volume using
- / + (Volume/Setting) button.
Check the connection
(see pages 7-8).
set to minimum.
Incorrectly connected.
No image from iPod.
iPod has incorrect
settings selected.
In the Settings menu of
your iPod, set the TV
Out setting to ON.
Check the connection
(see pages 7-8).
Incorrectly connected.
No video from iPod.
iPod not charging.
Incorrect iPod model
connection.
Only for iPod with video
(5th generation) and iPod
photo.
Mi8000 not connected
with the AC adapter.
The iPod can charge only
when the Mi8000 is
connected with the AC
adapter.
11
SPECIFICATIONS
GENERAL:
Power Source ................DC 12V Adapter (Center Positive)
Battery Pack..................................................................7.2V
Speaker...............................................................2 x 8 ohms
Output Power .......................................................2 x 1.2 W
Weight.......................................................................2.5 Lbs
Dimensions............................1.7" (H) X 8.7" (W) X 6.7" (D)
Weight and dimensions are approximate.
Specifications are subject to change without notice.
This product has been designed specifically to work with iPod
and has been certified by the developer to meet Apple
performance standards. Includes iPod Universal Dock.
Compatible with any iPod with dock connector.
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE,
PLEASE VISIT OUR WEBSITE AT:
WWW.MEMOREXELECTRONICS.COM
OR CONTACT CUSTOMER SERVICE AT (954) 660-7100.
PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90
DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR
PLACE OF PURCHASE OR MEMOREX.
FOR
PARTS
AND
ACCESSORIES,
CONTACT
FOX
INTERNATIONAL AT 1-800-321-6993.
12
Memcorp, Inc. Weston, FL Printed in Hong Kong
Memcorp, Inc. Weston, FL Impreso en Hong Kong
iPod is a trademark of Apple Computer, Inc., registered in the U.S.
and other countries. This product has been designed speciꢀcally
to work with iPod and has been certiꢀed by the developer to
meet Apple performance standards. Includes iPod Universal
Dock. Compatible with any iPod with dock connector.
iPod es una marca registrada de Apple Computer, Inc. registrada
en EE. UU. y otros países. Este producto ha sido diseñado
especíꢀcamente para funcionar con los reproductores iPod. El
fabricante certiꢀca que cumple con las normas decalidad de
Apple. Incluye la base Dock universal compatible con cualquier
modelo de iPod apto para la base Dock.
|